SEALING AND IP67 TESTING FOR THE ELECTRONICS INDUSTRY

From consumer electronics to autonomous driving sensors, water and moisture resistance — IP standards — is no longer a luxury, but a production necessity. Adlema’s 100% dry and non-destructive testing technologies verify your microchips, sensors and smart devices within seconds, without exposing them to the risk of water immersion. Eliminate the risk of short circuits and corrosion on your production line.

Leave Water Immersion Tests Behind: 100% Dry NDT

Immersing electronic devices in water tanks to verify waterproofing is a primitive method that invites corrosion and potential short circuits. Moreover, if the device leaks, it is discarded together with the expensive electronic board inside.

Adlema BT3000’s “Volumetric Pressure” technology tests sealed electronic enclosures in a completely dry environment using air. If there is a leak, the device does not get wet, allowing you to save the product and reprocess it.

Micron-Level Hermetic Sealing for Sensors and Optics

For security cameras, autonomous driving radars — LiDAR — and optical sensors, sealing does not only mean keeping water out. Micron-level moisture or ambient air entering the device can cause internal lens fogging during temperature changes and make the sensor blind.

Adlema’s high-resolution test devices and HVC — Helium Vacuum Chamber — systems verify the absolute insulation of hermetically packaged components and sensors in line with aerospace standards.